![background image](http://html1.mh-extra.com/html/multiquip/mq600td80/mq600td80_operation-and-parts-manual_1855341019.webp)
MQ600TD80 TRASH PUMP — OPERATION AND PARTS MANUAL — REV. #8 (11/13/09) — PAGE 19
MQ600TD80 — COMPONENTS
Figure 3 shows the location of the components and basic
components for the MQ600TD80 trash pump, The function
of each component or control is described below:
1.
Pump End Jack Stand –
Use this jack stand to level
and support the trash pump.
2.
Pump Discharge Port –
Discharges water and debris
from the pump.
3.
Bearing Sight Glass –
Use this sight glass to determine
if oil is present. Oil must be
visible
within the sight
glass at all times.
4.
Mechanical Seal Sight Glass –
Use this sight glass to
determine if oil is present. Oil must be
visible
within the
sight glass at all times.
5.
Battery –
+12 VDC battery compartment.
6.
Control Box Panel –
Monitors engine functions and
will shut down the engine for low oil pressure, high
coolant temperature, alternator charge and V-belt failure.
7.
Muffler/Guard –
DO NOT
touch the muffler when
engine is running. The muffler can become extremely
hot, causing severe burns.
NEVER
run the pump with
the muffler guard removed.
8.
Lifting Bail –
When lifting of the trash pump by crane is
required, use this lifting bail. Note: this lifting bail is
balanced for a fully configured trash pump; removal of
any trash pump components will un-balance the lifting
bail.
9.
Oil Bath Cleaner –
Prevents dirt and any foreign debris
from entering the engine. Service this unit as
recommended in the maintenance section of this
manual.
10.
Tow End Jack Stand –
Use this jack stand to level and
support the trash pump.
11.
Brake Coupler –
This device will activate the hydraulic
braking system of the pump's trailer in the event the
pump's trailer becomes detached from the towing
vehicle.
12.
Tow Hitch Coupler –
Requires a 2-5/16 ball hitch or a
3-inch pintle.
13.
Safety Chain –
Always attach safety chain to the towing
vehicle.
NEVER!
tow the trash pump with the safety chain
unattached.
14.
Documentation Box –
Contains documentation for the
pump and engine.
15.
Engine Throttle Lever –
Controls the speed of the
engine. For load conditions (pumping water)
ALWAYS
run the engine at
full speed
.
16.
Oil Filler –
Fill as recommended in the maintenance
section of this manual.
17.
Engine (Diesel) –
This pump uses a Deutz FL913 air-
cooled, 4-stroke diesel engine. See the Deutz Operation
manual supplied with the trash pump for additional
engine information.
18.
Fuel Gauge/Filler Port –
Read top of gauge to
determine fuel level. Re-fuel using only recommended
types of diesel fuels (see Deutz Operation Manual). DO
NOT top off fuel, wipe up any spilled fuel immediately.
19.
Chock Blocks –
Place these blocks (not included as
part of the trash pump package) under each trailer wheel
to prevent rolling.
20.
Trailer Lights –
Before towing trash pump, make sure
that both trailer lights are functioning correctly.
NEVER
tow the trash pump if these lights are not working.
21.
Pump Shaft Guards –
To prevent injury to hands and
fingers these two guard covers (one each side of pump
housing) are to remain in place at all times when the
pump is in use.
22.
Dipstick –
Read this gauge to determine the level oil in
the engine crankcase. Fill with only recommended type
oil as referenced in the maintenance section of this
manual.
23.
Fuel Filters –
This pump design incorporates the use
of four fuel filters, maintain these filters as recommended
in the maintenance section of this manual.
24.
Fuel Water Separator –
Removes water from the fuel
system. Inspect and clean as recommended in the
maintenance section of this manual.
25.
Support Tubes –
These tubes protect the fuel tank from
being damaged when the pump frame is lying on a flat
surface.
26.
Fuel Tank/Drain Plug –
The fuel tank is part of the
frame (sides). It holds 40 gallons (51 liters) of diesel
fuel. Remove this drain plug to drain the fuel tank.
27.
Pump Intake Port –
Intakes water and debris from the
source.
28.
Fill Cap –
Remove this cap to prime the pump with water.
29.
Clean-Out Cover –
Remove this cover to clean and
remove foreign debris from the trash pump.
30.
Accessories –
Hoses, strainers and clamps are the
required accessory components for normal operation
of this trash pump.
Contact
your nearest Multiquip
dealer for information on the components.
Summary of Contents for MQ600TD80
Page 3: ...MQ600TD80 TRASH PUMP OPERATION AND PARTS MANUAL REV 8 11 13 09 PAGE 3 NOTES...
Page 15: ...MQ600TD80 TRASH PUMP OPERATION AND PARTS MANUAL REV 8 11 13 09 PAGE 15 NOTES...
Page 41: ...MQ600TD80 TRASH PUMP OPERATION AND PARTS MANUAL REV 8 11 13 09 PAGE 41 NOTES...
Page 65: ...MQ600TD80 TRASH PUMP OPERATION AND PARTS MANUAL REV 8 11 13 09 PAGE 65 NOTES...