![background image](http://html1.mh-extra.com/html/multiquip/globug-gb12bp/globug-gb12bp_operation-and-parts-manual_1855133019.webp)
GLOBUG LIGHTING SYSTEM — OPERATION AND PARTS MANUAL — REV. #2 (11/03/08) — PAGE 19
Applying Power (GB12BW)
1. If using a portable generator, start the generator as
referenced in the "Start-up Section" of the supplied
generator manual.
2. Once the generator has started, plug the AC power cord
from the lamp into a GFCI receptacle on the generator.
3. If using power source (Figure 17) other than a portable
generator, plug the AC power cord from the lamp into a
120 VAC, 60 Hz receptacle that is protected by at least
a 15 amp circuit breaker.
Figure 17. 120 VAC Receptacle
Shutdown
1. If using a portable generator, shut-down the generator
as referenced in the "Shutdown Section" of the supplied
generator manual.
ALWAYS
place the main circuit
breaker in the
OFF
position before turning off the
generator.
2. If using a power source other than an AC generator,
disconnect the lamp AC power cable from the power
source. The balloon should begin to deflate.
CAUTION - LAMP COOL DOWN
Allow a sufficient amount of time (15-20 minutes) for the
lamp to
cool down
. The possibility exists of the balloon
getting burned (touching the lamp).
EXTERNAL
SINGLE-PHASE
(120 VAC)
POWER SOURCE
POWER CABLE
RECEPTACLE
4. Notice that the balloon envelope will begin to deploy as
soon as power is applied.
5. The lamp should now be on. If the lamp is not on, check
all connections and repeat steps 1 and 2. If the lamp
still does not come on, refer to the troubleshooting tables
provided in the maintenance section of this manual.
6. The GB12BW lighting system is now ready for use.
Storage
1. Loosen the lower T-handle by turning handle
counterclockwise (Figure 19). Push down on mast until
mast is fully inserted into mast housing. Tighten T-handle
fully.
LOWER
T-HANDLE
Figure 19. Lowering the Mast
3. Disconnect lamp power connector (Figure 18) from the
AC power cable.
Figure 18. Disconnecting Power Cables
2. Unzip the zipper on the protective cover (Figure 20),
and pull down cover over balloon/lamp assembly.
GLOBUG GB12BW/BS/BP LIGHTING SYSTEM — OPERATION (GB12BW)
Go
to
Discount-Equipment.com
to
order
your
parts