![background image](http://html1.mh-extra.com/html/multiquip/globug-gb12bp/globug-gb12bp_operation-and-parts-manual_1855133018.webp)
PAGE 18 — GLOBUG LIGHTING SYSTEM — OPERATION AND PARTS MANUAL — REV. #2 (11/03/08)
5. Attach the S-type hook (Figure 15) on the AC power
cable onto the washer-eylet located on the bottom plate
of the light assembly.
S-TYPE
HOOK
WASHER
EYELET
BOTTOM
PLATE
Figure 15. Securing Power Cord
2. To improve stability and to prevent tipping of the light
unit, place sand bags or similar type weight over the
tripod legs or weight hook as shown in Figure 16.
Figure 16. Sand Bags
GLOBUG GB12BW/BS/BP LIGHTING SYSTEM — SETUP (GB12BW)
3. Raise mast to desired height and tighten lower T-handle
(Figure 16) securely.
SAND
BAGS
MAST
RAISE
LOWER
T-HANDLE
UPPER
T-HANDLE
WEIGHT
HOOK
Raising the Mast (GB12BW)
1. Before raising the mast, make sure the upper T-handle
bolt lock (Figure 16) is securely tightened. This will
prevent the balloon/lamp assembly from falling off. In
addition make sure that the lamp power cable is
connected to the mating end of the 15 ft (4.5 meters)
power source cable.
ALWAYS
make sure the
area above the lighting
system is open and clear of
overhead power lines and
other obstructions. The mast
extends in excess of 13 ft. (4
meters) when an optional
exrension is used. Contact
with overhead power lines or
other obstructions could
result in equipment damage,
Serious Injury or Death
!
DANGER -
Overhead Obstructions
DANGER - HIGH VOLTAGE POWER LINES
When raising mast,
ALWAYS
be on
the lookout for overhead obstructions
such as high voltage power lines. The
possibility exists of electrocution,
even death! if the lighting system comes in contact with
high voltage power lines
.
CAUTION - MAST PINCH POINT
When raising or lowering the mast, keep hands and fingers
clear of the various mast sections. This will prevent hands
and fingers from getting pinched.
Go
to
Discount-Equipment.com
to
order
your
parts