![background image](http://html1.mh-extra.com/html/multiquip/gbc/gbc_operation-and-parts-manual_1855062009.webp)
GBC/GBCE LIGHTING SYSTEM • OPERATION AND PARTS MANUAL — REV. #1 (03/25/14) — PAGE 9
SAFETY INFORMATION
LOADING AND UNLOADING
Cart Type - With Lifi ting Hook
If lighting system is equipped with a transport lifting hook,
refer to the following safety information.
CAUTION
Before lifting, make sure that lighting system parts are
not damaged and screws are not loosened or lost.
ALWAYS
make sure crane or lifting device has been
properly secured to lifting hook of the equipment.
NEVER
lift the equipment while lighting system is
running.
Make sure the mast is completely lowered before lifting
the lighting system.
Use adequate lifting cable (wire or rope) of suffi cient
strength.
Use one point suspension hook and lift straight upwards.
Never allow any person or animal to stand underneath the
equipment while lifting.
DO NOT
lift machine to unnecessary heights.
AC CIRCUIT
BREAKER
120/240V
30A
120V
30A
20A
20A
0N
OFF
IDLE
CONTROL
OPERATION
SWITCH
ON
OFF
FULL POWER
SWITCH
120V
120V/240V
120
V
OFF
21A
LIFTING
HANGER
LIFTING
SCHACKLE
GENERATOR
LIFTING BALE
FORK LIFT
ALIGNMENT
ARROWS
(4 PLACES)
LIFTING
HOOK
Cart Type - No Lifi ting Hook
If lighting system is not equipped with a transport lifting
hook and the mast is removable, refer to the following
safety information.
Before lifting, make sure that the mast and lamp are
removed as described in the manual.
The cart can be safely lifted by two persons to the
transport vehicle.
TRANSPORTING SAFETY
NOTICE
When transporting the lighting system, if applicable,
always place in
stow position
and place mast in its
carrying case.
ALWAYS
remove balloon/lamp assembly from the mast
when transporting lighting system. This will prevent
damage to the bulb due to vibration.
NEVER
leave the balloon/lamp exposed during transport.
Exposure to excess wind or rain could damage the
balloon’s nylon cover.
ALWAYS
place balloon inside its protective cover during
transport. Be sure the cover is secured tightly around the
balloon/lamp assembly.