gBC/gBCe lighting system • operation and parts manual — rev. #1 (03/25/14) — page 15
Components
Figure 3 shows the location of the controls and components
for the GBC/GBCE Lighting System. The functions of each
control is described below:
1.
Balloon Cover
— Stores balloon when GBC/GBCE
is not in use. Allow a sufficient amount of time for the
lamp to cool down before storing balloon. Possibility
exists of balloon getting burned.
2.
Balloon
— Made of heat resistant polyester, with a
diameter of 47.2 inches (1,200 mm). Balloon is self-
inflating and inflates in less than 20 seconds.
3.
velcro
— Used to easily attach optional message strip
to the balloon.
4.
Buckle
— Used to hold the balloon together when
storing inside the cover.
5.
aC power Cable
— connects to the AC power source
(generator) on one end and to the lamp connector on
the other end with quick-disconnect connector.
6.
Cart
— holds the generator and can be steered easily
to transport GBC/GBCE to different locations
.
7.
locking Clamps
— To secure the generator to the cart
platform, place clamps around the pipe frame of the
generator. Tighten securely to prevent movement.
8.
tire
— The GBC/GBCE uses four pneumatic tires for
easy maneuverability.
9.
Brake pad
— When the brake pedal is pressed, this
pad will strike and hold the rear tires in place.
10.
strap slots
— Allows suitcase generators to be
strapped to cart securely.
11.
outriggers
— provides stability to the GBC/GBCE.
When raising the mast, outriggers should always be
deployed.
12.
Counter Weight
— Locks the outriggers in place when
they are deployed or stowed.
13.
Brake pedal
— Step on this pedal and pull back
T-handle to apply the brakes. To release the brakes,
press down and hold brake pedal again then release.
14.
t-handle
— Moves the GBC/GBCE in either forward
or reverse direction by pulling back or pushing forward.
The T-handle also allows the cart to be steered left or
right.
15.
mast
— This mast is comprised of three separate
stages. The mast can be raised in excess of 8 feet
(without balloon).
16.
mast Bolt
— Loosen to raise mast and tighten to keep
the mast in place when raised to the desired height.
17.
aC power Cable Connector
— Connect this quick-
disconnect plug to the balloon connector.
18.
message strip (optional)
— a 12 x 43 inch
message strip (Part No. GBBALD1) may be attached
to the balloon. The message strip can be purchased
separately.
19.
Zipper
— Zips up balloon to completely close it when
lamp is in place.
20.
lamp holder
— Holds lamp in place. Lamp is screwed
into socket.
21.
Balloon Connector
— Connect this connector to the
AC power cable connector.
22.
lamp/Balloon Bolt
— used to tighten mast when
attached to the lamp/balloon assembly.
23.
Fan motor (Blower)
— inflates the balloon as soon
as power is applied to the GBC/GBCE.
24.
lamp
— 1000 watt metal halide bulb with pure white
light for maximum illumination.
25.
lamp guard
— Protects the lamp from being hit by
objects and balloon material from touching lamp.
26.
extension pole (gBCe only)
— Extends mast height
by 40 inches.
Warning
When raising the mast, always be on the lookout for
overhead obstructions.
