![background image](http://html1.mh-extra.com/html/multiquip/ca4hc-whiteman-series/ca4hc-whiteman-series_operation-manual_1855055019.webp)
CA4HC WALK-BEHIND TROWEL — OPERATION MANUAL — REV. #0 (09/29/06) — PAGE 19
Pitch Cable Installation
1.
Expose the pitch cable to maximum by adjusting the handle
pitch to the "no pitch", counter-clockwise position (Standard
Handle)(Figure 9). Pivot the pitch handle forward or no
pitch for the folding Quick Pitch handle, (Figure 10).
Figure 9. Pitch cable (Standard Handle)
Figure 10. "No Pitch" Position (Quick Pitch Handle)
The Quick-Pitch™ handle is spring loaded, personal injury
or damage could result from improper handling or
installation. Be careful when installing this component.
Considerable force may be
required when moving the Quick-
Pitch
™
handle forward or
backward.
CAUTION
CAUTION
CAUTION
CAUTION
CAUTION
NOTE
2.
Remove any nuts from the pitch cable end. Insert the cable
through the yoke eyelet, (Figure 11). Thread the conical
nut up to the eyelet first. Tighten the conical nut by hand to
remove all the slack from the cable.
3.
Thread the brass locking nut up to the conical nut. Use a
wrench to tighten the conical nut up against the yoke boss.
This will lock the cable in place. Use a wrench to tighten up
the brass nut up against the yoke boss.
Figure 11. Pitch Cable to Yoke Install
CA4HC TROWEL— HANDLE ASSEMBLIES
2
3
4
1
1
Throttle Lever
2
Throttle Cable
3
Idle Detent
4
Thumbwheel Adjuster
Figure 8. Throttle Cable Adjust
1
2
3
4
1
Yoke Eyelet
2
Yoke
3
Conical Nut
4
Locking Nut