![background image](http://html1.mh-extra.com/html/multiquip/ar14h/ar14h_operation-manual_1854956015.webp)
AR14H RIDE-ON ROLLER • OPERATION MANUAL — REV. #3 (09/06/19) — PAGE 15
COMPONENTS
Figure 4 shows the location of the components and controls
(1 of 3) for the AR14H compaction roller. The function of
each component or control is described below:
1.
Water Volume Control Valve
— This valve controls
the volume flow of water to the front and rear spray
bars. Turn the valve to the counterclockwise to increase
water flow and clockwise to decrease water flow.
2.
Travel Lever
— Push the lever forward to make
the roller travel in a forward direction. Pull the lever
backward to make the roller travel in a reverse direction.
Maximum travel speed is 4.8 MPH (7.7 KPH). Center
position is neutral; no travel.
3.
Vibration Control Switch
— Toggle switch to activate
the eccentric that will produce a vibration frequency of
4,200 vpm (vibrations per minute). Toggle switch again
to stop vibration.
4.
Water Pump Switch
— Activates the water pump. The
water pump indicator turns on.
5.
Hour/Tachometer
— Indicates the number hours the
unit has been in use when engine is off and RPM when
engine is running.
6.
Choke Knob
— Used in the starting of a cold engine,
or in cold weather conditions. The choke enriches the
fuel mixture.
7.
Throttle Control
— Slide control to the left to increase
engine rpm. Slide to the right to decrease engine rpm.
Slide all the way to the left to achieve maximum engine
rpm.
8.
Steering Wheel
— Use this wheel to steer the roller.
9.
Steering Wheel Knob
— Use this knob to move the
steering wheel with one hand.
10.
Engine Oil Indicator
— Lights to indicate low engine
oil level. The engine will automatically turn off. Add oil
as necessary.
11.
Water Pump Indicator
— Lights when the water
pump is on.
12.
Seat Belt
— When operating the roller, always have
the operator wear the seat belt.
NEVER
use the roller
without wearing a seat belt. If the seat belt becomes
worn or damaged, replace it immediately.
13.
Parking Brake Lever
— Pull the lever upward to
engage the parking brake. To release the parking brake,
push lever downward.
14.
12V Power Outlet
— Charges small portable electronic
devices.
15.
Hydraulic Motors
— These hydraulic motors provide
forward/reverse drive for drums.
16.
Tie-Down Transport Points (Front and Rear)
—
Attach a chain or suitable tie-down device to these
when transporting of the roller is required.
17.
Rear Drum Roller Scraper Bars (2)
— Helps prevent
the buildup of material between the drum and frame.
The scraper bar is spring-loaded for easy change and
clean up. No tools are required.
18.
Rear Drum
— This is a 35.6-inch wide steel drum
with a diameter of 22 inches. It has beveled edges to
help prevent asphalt marring. The rear drum has a
water ballast allowing 34 gallons of water to add 292
of static force.
19.
Compartment Hood
— Houses the engine, hydraulic
manifold, accessory relay, hydraulic oil filter, hoses,
and hydraulic pump. To lift the compartment hood,
release the rubber bungee latch located on the front
of the hood.
20.
Compartment Hood Lift Point
— Place hand here
on either side of the roller then lift compartment hood.
21.
Bungee Latch
— Pull this rubber latch upward and
back to gain access to the engine/pump compartment.
TRANSPORT
TIE-DOWN POINT