Multiplex MB-8-1, Technician'S Handbook

Page: 68 / 178

68 Part Number STH034 3/12
4. Remove ice dispense motor assembly by
removing four thumbscrews. Place motor
assembly in a location that it will not fall.
5. Remove ice chute by removing two thumbscrews.
There is a gasket between the ice chute and ice
extruding head, remove it.
6. Remove ice bin cover and place cover in a
location that it will not fall.
7. Remove all ice manually and discard. Be cautious
of the washer in between the ice agitator and the
bottom of the ice bin.
8. Use an approved cleaning solution as noted
below.

NOTE: For safety and maximum effectiveness, use
the solution immediately after dilution.
Mix 10 fl. oz. (296 ml) “LIME-A-WAY” (Economics
Laboratory, Inc.) with 2 gallon (6 l) of warm water
or follow the dilution instructions and warnings on
descaler bottle.
9. Use an approved sanitizing solution or mix 1
ounce of household bleach to 2 gallons of warm
(95°F-115°F) water.
10. Remove ice agitator. clean, rinse and sanitize the
ice agitator.
11. Remove the dispense wheel assembly.
12. Locate small washer, it will be stuck to the
bushing or inside the agitator shaft.