MultiMix Simplex Eco, Installation & Operating Instructions Manual

Page: 5 / 64

OPERATING CONDITIONS & REQUIREMENTS
Page 5
EN - English

APPLICATION LIMITATIONS:

pH: 5-10

maximum contaminant content:
Water hardness 75 °f / 42 °d
Iron (Fe
2+
) 15 mg/L
Manganese (Mn
2+
) 3 mg/L
Oxidizability (O
2
) 4 mg/L
Ammonia (NH
3
) 4 mg/L

OPERATING PRESSURE: MIN-MAX: 1,4-8,3 bar / 20-120 psi

this system is configured to perform optimally at an operating
pressure of 3 bar (±½ bar); in case of a lower or higher operating
pressure the performance may be affected negatively!

check water pressure regularly; it may fluctuate severely
depending on the time of day, the day of the week or even the
season of the year.

take into account that night time water pressure may be
considerably higher than day time water pressure.

install a pressure reducer ahead of the appliance if necessary.

install a pressure booster, if it is likely that water pressure may
drop below the minimum.

OPERATING TEMPERATURE: MIN-MAX: 2-48 °C / 35-120 °F

do not install the multi-purpose water filter in an environment
where high ambient temperatures (e.g. unvented boiler house)
or freezing temperatures can occur.

the multi-purpose water filter cannot be exposed to outdoor
elements, such as direct sunlight or atmospheric precipitation.

do not install the multi-purpose water filter too close to a water
heater; keep at least 3 m of piping between the outlet of the
multi-purpose water filter and the inlet of the water heater;
water heaters can sometimes transmit heat back down the cold
pipe into the control valve; always install a check valve at the
outlet of the multi-purpose water filter.

ELECTRICAL CONNECTION: 230V-50Hz

this multi-purpose water filter only works on 24VAC; it is
equipped with a 230/24V-50Hz transformer; always use it in
combination with the supplied transformer.

make sure to plug the transformer into a power outlet, which is
installed in a dry location, with the proper rating and over-
current protection.