SilverBack V Camera-Mountable Fiber Optic Transmission System
© 2021 MultiDyne, Inc.
Made in the USA
Page
34
To talk on both intercom channels simultaneously (latching Mode only):
1.
Quickly press and release the PTT switch for channel 1.
2.
The microphone will latch open and the TALK and Ch1 TALK LEDs will blink continuously.
3.
Quickly press and release the PTT switch for channel 2.
4.
The microphone will stay open and the Ch2 TALK LED will now also blink continuously.
5.
When finished with the conversation, quickly press and release the PTT 1 switch again to shut
off channel 1 and then repeat for channel 2.
6.
The microphone will shut off and the TALK LEDs will turn off.
Serial Data Settings
The SilverBack V camera unit’s Serial Data Channel settings are configured in the Data Settings Menu.
Each data port can be configured for RS232/RS422 type data or LANC control data. The factory default
setting is RS232/422.
To configure a data channel, navigate to the Main menu and select Data Settings. Move to the Data 1
selection line and press Enter to toggle through the available settings. Then move to the Data 2 selection
line and press Enter to toggle through the available settings.
MENU > Data Settings >
•
Data 1: 232/422 or LANC
•
Data 2: 232/422 or LANC
The Camera serial data settings may also be configured remotely, from the webpage dashboard
accessed from the Base Unit.
System Settings
The System Settings menu provides system information and allows control of some overall system
functions.
Timecode Settings
The SilverBack V camera unit has a single HDBNC connector for timecode transport. This connector can
be set as an input or an output, depending on the desired workflow. The factory default setting is
Output.
Timecode direction settings are found under the System menu. Navigate to the Main menu, select
