MultiChannel Wireless2100-System, Manual

Page: 12 / 43

Wireless2100 Interface Board
The interface board is the third element of the
Wireless2100-System
. It provides connectors for
additional analog input channels and digital trigger in- and outputs.
The interface board is connected to the receiver with an eSATAp cable. The connection to the data
acquisition computer is realized via USB 2.0 high speed cable. The interface board has an own power
supply.
Front Panel of the MCS Interface Board
Two Status LEDs
The status LEDs indicate the link status of receiver 1 and / or receiver 2. They light up when one or both
receivers are connected to the interface board via eSATAp cable.
Auxiliary Channels
Two reserve auxiliary channels are available for future use. They have no function at the moment.
Digital IN / OUT
A Digital IN / OUT for 16 digital in- and output bits is available (68-pin MCS standard connector) on the
rear panel of the interface board. On the front panel four digital IN and four digital OUT connectors bits
are also accessible via Lemo connector, DIG IN bit 0 to bit 3 and DIG OUT bit 0 to bit 3. If access to more
bits of the DIG IN / OUT channel is required, it is necessary to connect a Di/o board with a 68-pin standard
cable. This Di/o board is available as optional accessory.
Power LED
The power LED near to the MCS logo on the front panel of the interface board should light up when
the Wireless2100-System is "ON", and the device is connected to the power line. If not, please check
the power source and cabling.