MULTICHANNEL SYSTEMS W16-System, Manual

Page: 7 / 58

3
2 Important Information and Instructions
2.1 Important Safety Advice
Warning: Make sure to read the following advice prior to install or to use the device and the
software. If you do not fulfill all requirements stated below, this may lead to malfunctions or
breakage of connected hardware, or even fatal injuries.
Warning: Obey always the rules of local regulations and laws. Only qualified personnel should
be allowed to perform laboratory work. Work according to good laboratory practice to obtain
best results and to minimize risks.
The product has been built to the state of the art and in accordance with recognized safety
engineering rules. The device may only

be used for its intended purpose ;

be used when in a perfect condition .

Improper use could lead to serious, even fatal injuries to the user or third parties and damage
to the device itself or other material damage.
Warning: The device and the software are not intended for medical uses and must not be used
on humans.
Malfunctions which could impair safety should be rectified immediately.
High Voltage
Electrical cords must be properly laid and installed. The length and quality of the cords must
be in accordance with local provisions.
Only qualified technicians may work on the electrical system. It is essential that the accident
prevention regulations and those of the employers' liability associations are observed.

Each time before starting up, make sure that the mains supply agrees with the specifications
of the product.

Check the power cord for damage each time the site is changed. Damaged power cords should
be replaced immediately and may never be reused.

Check the leads for damage. Damaged leads should be replaced immediately and may never
be reused.

Do not try to insert anything sharp or metallic into the vents or the case.

Liquids may cause short circuits or other damage. Keep the device and the power cords always
dry . Do not handle it with wet hands.
Requirements for the installation
Make sure that the device is not exposed to direct sunlight. Do not place anything on top
of the device, and do not place it on top of another heat producing device. Never cover the
events, not even partially, so that the air can circulate freely. Otherwise, the device may overheat.