TABLE OF CONTENTS
PAGE
OPERATING INSTRUCTIONS MANUAL
WARNING:
1. Each person involved in the assembly, installation and/or maintenance of the
Hydro-Guard Automatic Flushing Device must read this manual carefully and follow
all instructions prior to performing any installation or maintenance procedures
involving the Unit.
2. Verify the drainage path prior to installation to ensure that pedestrian and
vehicular hazards will not be created by the installation and use of the Hydro-
Guard Automatic Flushing Device (In areas in which freezing may occur, special
attention should be given to this procedure).
3. Never assemble, disassemble, or perform Hydro-Guard maintenance unless the
influent supply valve has been closed, verified and secured, and internal piping
pressure has been relieved.
4. Always use all necessary safety equipment and follow all recommended
procedures when installing, operating and maintaining the Hydro-Guard Automatic
Flushing Device.
5. Replace worn or defective parts with OEM parts and check your battery twice a
year.
6. Operate the Hydro-Guard Automatic Flushing Device only when fully installed and
correctly assembled.
7. It is recommended that a pressure reducing valve be installed in front of the
Hydro-Guard where pressure could exceed 120 psi.
CAUTION:
The recommended optimal operating pressure for a Hydro-Guard® Automatic Flushing
System is between 20 psi and 120 psi. In the event pressure may exceed 120 psi
it is recommended that a Pressure Regulating Valve be installed ahead of the
Hydro-Guard flushing system.
200 Series
Warm Climate
High-Profile
Direct Discharge
Unit
Installation Instructions
2
Programming Unit
3 - 5
Options and Upgrades
6
Disassembly/Reassembly of Unit
7
Troubleshooting 8
Parts 10
Notes 11
F 12772 7/21
!
!
