BULLDOG 65 Hydraulic Steelworker
19
6
6
6
6
ANGLE CUTTI
ANGLE CUTTI
ANGLE CUTTI
ANGLE CUTTING
NG
NG
NG
6.1
6.1
6.1
6.1
D
D
D
D
ESCRIPTION
ESCRIPTION
ESCRIPTION
ESCRIPTION
This working station provides large capacity angle cutting at 90 degrees and lighter angle
cutting at 45 degrees.
To cut angle section, place the material through the hold down into the cutting area, adjust the
support screw to the material but leave sufficient clearance to enable the section to be fed on
for progressive cutting.
To mitre cut at 45 degrees:
firstly cut the angles to length allowing apprx.
1/2
’’ oversize for end trimming.
1.
Place the first end into the blade using the higher support position, trim approx. 6mm off
the end of the section whilst maintaining 45 degrees to vertical position.
2.
Place the other end into the blade using the left hand support position, trim
section to length whilst maintaining 45 degrees to face of machine position.
To achieve other angles of cut between 45 degrees and 90 degrees, first cut the angle section
to length and then trim the flange to required angle in the shear station.
The slot in the shear hold down allows angle sections to be positioned for left hand on right
hand trimming, ensure hold down is set for relevant thickness.
Each cutting blade has four cutting edges and is retained by simple fixing screws.
DO NOT resharpen these blades, after turning four times replace with new blades.
WHEN ORDERING REPLACEMENT BLADES, ALWAYS QUOTE -
MODEL, TYPE AND SERIAL NUMBER OF MACHINE.
