Centrifugal oil filter, cleaning
and filter sleeve replacement
1.
Remove clamp (17).
2.
Release Tommy nut (2) and remove cover (1).
3.
Carefully lift rotor (14), allow oil to drain and
remove from housing.
Note:
Do not clamp rotor in a bench vise.
4.
Holding rotor unit (14) firmly, release rotor
cover nut (3).
5.
Take off rotor cover (3).
6.
Measure layer thickness of oil residues on fil-
ter sleeve (6).
Result:
If the oil residue exceeds the maximum layer
thickness of 45 mm, shorten the mainte-
nance interval.
7.
Remove filter sleeve (6).
8.
Disassemble rotor tube (7), conical disk (8)
and rotor base (13).
9.
Wash rotor cover (3), rotor tube (7), conical
disk (8) and rotor base (13) with cold cleaner.
10.
Blow out with compressed air.
11.
Check sealing rings (9, 10, 12) and replace if
necessary.
12.
Coat sealing rings (9, 10) with assembly com-
pound and insert in grooves on bearing shaft
(11).
13.
Assemble rotor tube (7), conical disk (8) and
rotor base (13) with sealing ring (12).
Note:
Observe markings and information on paper
element!
14.
Insert new filter sleeve (6) in rotor tube (7)
with the smooth paper surface facing the out-
er wall.
15.
Check sealing rings (4, 5) and replace if nec-
essary.
16.
Insert sealing ring (5) in rotor tube (7) and
sealing ring (4) in rotor cover (3).
222 | Oil Filtration / Cooling | MS15035/00E 2018-08
TIM-ID: 0000065398 - 004
Summary of Contents for 12V4000M*3 series
Page 1: ...Operating Instructions Diesel engine 12V4000Mx3x 16V4000Mx3x MS15035 00E...
Page 3: ......
Page 4: ......
