Installing lambda sensor
Note:
The sensor is considered defective after be‐
ing exposed to shock load or impact and
must not be used.
1.
Remove the protective cap from the thread
immediately before installation.
Note:
Do not wipe off the grease the manufactur‐
er applied on the thread.
2.
Manually screw sensor into bore.
3.
Tighten nut (2) to specified tightening torque using a torque wrench.
Name
Size
Type
Lubricant
Value/Standard
Sensor
M18 x 1.5 Tightening torque
40 Nm to 60 Nm
4.
Fit male connector (1) and latch.
Note:
The CDC parameters must be reset, otherwise the emission certification of the engine is no longer appli‐
cable.
5.
Reset CDC parameters (→ Page 117).
112 | Task Description | MS150094/01E 2012-08
TIM-ID: 0000025194 - 002
