Cleaning centrifugal oil filter and
replacing filter sleeve
1.
Undo screw (1) and remove.
2.
Remove clamp (3) and take off hood (2).
3.
Carefully remove rotor (5) from housing.
4.
Hold rotor assembly (5) firmly in position
with filter wrench and undo knurled nut (7).
5.
Take off rotor cap (8).
6.
Remove filter sleeve (9), stiffener plate (10)
and sealing ring (11).
7.
Measure thickness of oil residues on filter
sleeve.
8.
If maximum layer thickness of oil residues
exceeds 30 mm, shorten maintenance in‐
terval.
9.
Remove standpipe (12) from lower rotor
section (13).
10.
Wash hood (2), rotor cap (8), stiffener
plate, (10) standpipe (12), rotor lower sec‐
tion (13) and nozzles (14) with cold cleaner
and blow out with compressed air. Do not
use sharp objects for cleaning.
11.
Check nozzles (14) for obstructions.
12.
Press standpipe (12) onto rotor lower sec‐
tion (13).
13.
Insert new filter sleeve (9) with stiffener
plate (10) into rotor cap (8), ensuring that
smooth surface of filter sleeve (9) faces ro‐
tor cap (8).
14.
Check sealing ring (11), replace if necessa‐
ry. Coat sealing ring with grease and insert
in groove of rotor cap (8).
15.
Place rotor cap (8) onto standpipe (12).
16.
Hold rotor assembly (5) firmly in position
with filter wrench and tighten knurled
nut (7).
17.
Lubricate bearings of rotor (5) with oil, in‐
sert into housing (6) and check for ease of
movement.
18.
Check sealing ring (4), replace if necessary.
Fit sealing ring on housing (6).
19.
Fit hood (2).
20.
Tighten screw (1) by hand.
21.
Install clamp (3) and tighten to specified torque using a torque wrench.
Name
Size
Type
Lubricant
Value/Standard
Clamp
Tightening torque
6 Nm + 1 Nm
22.
Tighten screw (1) to specified torque using a torque wrench.
Name
Size
Type
Lubricant
Value/Standard
Screw
Tightening torque
6 Nm + 1 Nm
104 | Task Description | MS150064/01E 2011-11
TIM-ID: 0000000958 - 003
