35
Black MXv4 (RF) with MTS logo remote:
1. Position your MTS TV remote 1-2 inches away from the device remote. Make sure the infrared ends of the
remotes are pointed toward each other.
2. Press and hold
SETUP
until the LED lights blink twice
3. Press
975
on the number key pad
4. Press the desired mode key on the MTS TV remote (
TV
,
DVD
, or
AUX
) for the device you wish to set up, then
the key on the MTS remote that you want to teach
5. Press and hold the desired key on the teaching remote until the mode key on the MTS TV remote blinks twice
6. Repeat steps 2-5 to learn other keys from the original device remote
7. To exit learning mode, press and hold
SETUP
until a mode key blinks twice
e pointed toward each other.
MXv4 Remote (RF)
Your original remote
Troubleshooting learning (Black MXv3 & MXv4 remotes only
)
• No functions may be stored under the
LEARN/SETUP
key, or in the
STB/MTS
mode
• Depending on the remote you are trying to learn from, some keys may not be teachable
• Only one original device type can be learned per individual mode
• Use fresh batteries for your original remote, and your MTS TV remote control
• Keep at least three feet away from incandescent or low energy lights when learning
• Point your original remote so the infrared elements on both remotes are directly in line with each other. You may
need to adjust the height of the remotes to achieve this
• If you keep experiencing errors while learning the
fi
rst or second keys for a mode, then try the following:
• End the learn session by pressing the
LEARN/SETUP
key
• Clear out the learned commands for that mode
• Check the infrared elements of the two remotes are correctly aligned
• Change the distance between the two remotes to be either closer (half an inch) or further away (2 inches) from
each other
Try learning the original remote for that mode again. If problems reoccur with the same key, check the original
remote key being learned – does it transmit? Does it operate the target device?
Try learning that key under a di
ff
erent clear mode. If it learns, then it is likely a di
ff
erent code type from the others
and cannot be learned under the same mode.
Set volume options for multiple devices
The default setting for your power, volume, and channel control are to control your MTS TV set-top box regardless of
the mode you are in. For example, even in DVD mode, the volume will still control the set-top box.
Volume control set up options for multiple devices
• The volume commands are sent to the set-top box unless the TV mode key has been programmed
• If the TV mode key has been programmed, the volume commands are sent to the TV from all mode keys
• If you’d like the volume commands to be sent to just one device – for example, to your home theatre set up and
not to the MTS TV set-top box or TV set – follow the instructions in Lock the Volume Controls to One Device
• If you’d like the volume command sent to di
ff
erent devices depending on which mode you are in, go to Volume
Control Depends on Device Selected
Summary of Contents for Ultimate TV
Page 1: ...MTS Ultimate TV User Guide...
Page 46: ...43 VIP 2262 Option 1 VIP 2262 Option 2...
Page 49: ...46 VIP 2262 Option 2...