5
Temposonics
®
ET Analog ATEX / IECEx / CEC / NEC / CCC Certified
Operation Manual
2/
See also applicable MTS Sensors terms of sales and delivery on
www.mtssensors.com
2.4 Safety instructions for use in explosion-hazardous areas
The sensor has been designed for operation inside explosion-hazarded
areas. It has been tested and left the factory in a condition in which it is
safe to operate. Relevant regulations and European standards as well
as Canadian and North American standards have been observed. Ac-
cording to Ex marking (see chapter “2.1 Intended use” on page 3)
and the ATEX, IECEx, , CEC, NEC and CCC certificates (attached to this
document), the sensor is approved only for operation in defined haz-
ardous areas.
2.5 Warranty
MTS Sensors grants a warranty period for the Temposonics
®
position sensors and supplied accessories relating to material
defects and faults that occur despite correct use in accordance with
the intended application
2
. The MTS Sensors obligation is limited to
repair or replacement of any defective part of the unit. No warranty
can be provided for defects that are due to improper use or above
average stress of the product, as well as for wear parts. Under no
circumstances will MTS Sensors accept liability in the event of offense
against the warranty rules, no matter if these have been assured or
expected, even in case of fault or negligence of the company.
MTS Sensors explicitly excludes any further warranties. Neither
the company’s representatives, agents, dealers nor employees are
authorized to increase or change the scope of warranty.
2.6 Return
For diagnostic purposes, the sensor can be returned to MTS Sensors.
Any shipment cost is the responsibility of the sender
2
. For a corre-
sponding form, see chapter “9. Appendix” on page 27.
NOTICE
When returning sensors, place protective caps on male and female
connectors of the sensor. For pigtail cables, place the cable ends in
a static shielding bag for electrostatic discharge (ESD) protection.
Fill the outer packaging around the sensor completely to prevent
damage during transport.
Summary of Contents for Temposonics E Series
Page 32: ......
