MTM SDS10-SAT-TATS-02, Operator'S Manual

Page: 2 / 8

Index
INSTALLATION AND CONFIGURATION ............................................................................................................ 2
NOTICE OF OPERATION ................................................................................................................................... 3
NOTICE OF MAINTENANCE ............................................................................................................................. 3
CHECK REGULARLY .......................................................................................................................................... 4
DIMENSIONS & PART LIST – SDS10-SAT-TATS-02 ............................................................................................ 5
INSTALLATION AND CONFIGURATION
•
Use the hose or soft tube to connect to the inlet and outlet. Reduces loss from
vibration.
•
Don’t stamp or cause the hose to regulate pressure in the pump.
•
Don’t hang on the pump or else the pump will break.
•
The suction head of inlet should be less than six metre (for water).
•
When installing the pump, please use the following water vibration modes to absorb
the vibration.
o
Installed Place – Install the pump horizontal and avoid installing on sloped
surfaces.
o
Installed Aspect – Pay attention to keep the silencer’s aspect down.
o
Installed Mode – When you firm up the pump, please install the buffer
between the pump and base to avoid the pump from breaking.
•
The direction for the inlet and outlet of the pipes can be tuned.
•
When choosing the tube, consider the calibre, tolerance and pressure resistance. This
helps to prevent the tube from breaking and leaking.
•
Please check and clean the inside of the tube before installation. Check for any iron
filling, trash or any other impurities inside. Otherwise, it may increase chance of the
pump breaking.
•
Choose the tube that will not break from negative feedback pressure when fluid
transfers.
•
Choose the correct tube size. Otherwise, insufficient suction if the tube is too big.
•
It is recommended to install the filter in the inlet. It can help reduce the chance of the
pump breaking and extends the life of the pump.
•
For the high air pressure connection:
o
Don’t use a tube too small in the air inlet.
o
Air pressure of inlet does not exceed 8.3kgf/cm
2
(bar).
o
Use the lubricant oil for cold-resistance and high-pressure resistance.
o
It is recommended to install the air filter regulator and lubricator (FRL) for the
air inlet. It helps to supply clean air and lubricant oil.