MTI DOOR/DRAWER LOCKS
™
PRODUCT MANUAL
3
MTI P/N 063-00244 rev A ©2019 MTI All Rights Reserved
www.mobiletechinc.com | T:800.426.6844
1
2
3a
3b
DOOR/DRAWER INSTALLATION
Lock
48mm
10
Latch
42mm
50mm
19
48mm
13.8
Space devices at least 4” apart.
Only use hand tools to install lock. Use of
power tools can damage the fixture.
Self-closing hinges may prevent proper
function of the door/drawer lock.
Note:
If the lock emits a slow, low
beep tone, then the motor is stuck
due to overtightening the mount-
ing screws. Slowly unscrew the
screw to the left of the battery door
(when the MTI logo is right-side-up)
one-quarter turn at a time until the
motor can spin, opening the lock.
Using the Drawer/Door Locks:
After programming the locks (see page 6 for initial setup), place the User Card
within 30 mm of where the lock is placed. One you hear a click, open the door
or drawer. Close door or drawer to relock.
Drill pilot holes for the lock mounting screws. See page 1
for a mounting template to assist in placement.
See diagram below for placement on a swinging cabinet
door:
For sliding doors, the 90° bracket can be removed from
the latch (using the #2 Phillips Screwdriver and the
9/32” socket) and hard mounted to a fixture with wood
screws. See diagram below for placement on a sliding
cabinet door:
Line up the holes on the lock with the pilot holes in the
fixture and secure into place with a Phillips-head screw-
driver.
