9
s
ectiOn
3 — a
sseMbly
& s
et
-u
p
Attaching The Lift Handle
Attach lift handle to lift bracket on the right side of auger
1.
housing assembly with two hex screws and two flange nuts
provided. See Fig. 3-13.
Fasten the lift cable to the lift handle with two of the cable
2.
ties provided. Pull the cable ties until snug and trim excess.
Mounting The Auger Assembly
IMPORTANT:
It will be necessary to have a second person assist
you to complete the following steps.
Install a shoulder bolt on each side of the tractor and
1.
secure with a lock nut. See Fig. 3-14.
Attaching The Chute Directional Control
Attach the chute directional control assembly to the upper
1.
lift link on the left side of the auger housing. Assemble with
two hex screws and two saddle washers as illustrated in
Fig. 3-11. Secure with two flange nuts.
Secure the upper chute crank rod (A) to the joint block on
2.
the lower chute crank rod with the cotter pin (B) provided.
See Fig. 3-12.
Fasten chute tilt cables to chute directional control with
3.
two of the cable ties provided. Pull cable ties until snug and
trim excess.
Upper Lift Link
Chute Directional
Control Assembly
Figure 3-11
A
B
Figure 3-12
Lift Handle
Lift Bracket
Figure 3-13
Shoulder Bolt
Figure 3-14
Summary of Contents for 190-032
Page 17: ...Notes 7 17...
