7
s
ectiOn
3 — a
sseMbly
& s
et
-u
p
Mounting The Undercarriage Assembly
NOTE:
There are two different styles of undercarriages, yours
may differ slightly from the following images.
If you have a 700 series tractor, remove the pin and wing
1.
nut or hex nut at the right rear of the undercarriage
assembly before installing the undercarriage onto your
tractor. See Figure 3-5.
NOTE:
To determine if you have a 700 series tractor, locate
the model plate found underneath the seat. If the fifth digit
from the left is a 7, then you have a 700 series tractor.
Remove and retain the four hairpin clips from the weld
2.
pins found on the top side of the undercarriage assembly.
Remove and retain the two clevis pins with hairpin clips.
This hardware is for later installation. See Fig. 3-6.
Manual PTO Undercarriage Assembly Setup
Position the undercarriage on the floor beneath your
1.
tractor close to the PTO cable. The small idler pulley should
be pointed towards the front of your tractor.
Attach the PTO cable to the idler bracket, then fit the cable
2.
into the slotted fitting as seen in Fig. 3-3.
Refer to Fig. 3-4 for correct position.
3.
Idler Pulley &
Idler Bracket
PTO Cable
Slotted Fitting
Forw
ard
Figure 3-3
Figure 3-4
Figure 3-5
Figure 3-6
Summary of Contents for 190-032
Page 17: ...Notes 7 17...
