MTD 190-032, Operator'S Manual

Page: 10 / 24

10 s
ectiOn
3— a
sseMbly
& s
et
-u
p
Position the auger housing assembly in front of the tractor. 2.
See Fig. 3-15. Lay the belt and support tubes on the
installation surface.
Carefully move the tractor forward (by pushing, NOT 3.
driving it) so that support tubes found on the rear of the
auger housing assembly are positioned between the
tractor’s front tires. Set the parking brake.
With the help of an assistant, lift up the auger housing and 4.
move it so that it rests over the shoulder bolts installed in
Step 1 of this section. See Fig. 3-14.
Maneuver the auger housing until the mounting holes line
5.
up. Insert the two quick release pins from your hardware
pack into the top hole on each side as seen in Fig. 3-16.
NOTE:
You will need to lift up on the front of the auger
housing in order to line up the holes.
Attaching Support Tubes
Secure the left support tube to the front of the 1.
undercarriage assembly with the clevis pin and hairpin
clip removed earlier in step 2 of the mounting the
undercarriage assembly section. See Fig. 3-17.
2. Repeat the previous step on the right side.
Attaching Reflectors
Peel off the backi ng from each of the reflectors to expose
the adhesive surface. Adhere the reflectors to the rear of the
tractor’s fender (one on the left and one on the right) so that the
reflectors simulate taillights.
Support Tube
Belt
Figure 3-15
Quick Release Pin
Figure 3-16
Figure 3-17