2016 MSpa
Service Manual
MSpa website: www.the-mspa.com
- 6 -
Heat Preservation Mat
is helpful to avoid heat loss from bottom and it provides better heat insulation results with the
inflatable bladder in use. It is recommended to have the MSpa heat preservation mats in between the spa and ground.
Consumer can also apply similar mat which is made of foam material or other material with heat insulation function.
It’s only possible to set up and leave the spa at outside temperature lower than 4°C as long as the spa has a
constant water temperature guaranteed more then 4°C. The spa can be used under low environment
temperature down to maximum -10°C ONLY. if it is set up properly to ensure no frozen water inside control box,
pipes or spa pool.
2.2 Filter Cartridge
MSpa filter cartridge – Item No. B0301964 is suitable for all bubble spa products.
B0301964
Filter cartridge
2.3 Inflate and Deflate the Spa to Avoid Air Leakage
If customers complains about spas cannot be inflated upon inflating the spa pool with black pipe or their spa pool has
got an air leakage, the first step is to make sure if the spa is inflated correctly.
First air valve stopper:
Unscrew only
the squared air valve stopper.
The second valve
is for air tightness and deflation of the spa pool.
Please ensure the
customers manage the air valves correctly for inflation or deflation purpose.
2.4 Ensure Well Connection of the Signal Cable between Control Panel and Control Box
"ON/OFF" button shows red if the connection correctly. No bent or wet for the pin inside male connector which will cause
failure connection.
2.5 Avoid Air Leakage from Spa Liner Split or Tiny Holes Due to Over-inflation
Ensure to ask customers to test the spa pool air pressure with manometer. Testing air pressure is
very critical during the installation process, because any air leakages, pool liner splits due to over
inflation are not covered by the ORPC/MSpa warranty. It is important to advise customers to watch
the MSpa DVD or follow the instruction manual carefully to check and test the air pressure every
single time before inflating or using the spa.
Inflate
: Only unscrew this square
stopper for inflation
Deflate
: Unscrew the black stopper
for deflation of the spa pool
