M E A S U R E M E N T S Y S T E M S I N T E R N A T I O N A L
Page 20
MSI-4260
Port-A-Weigh
•
User Guide
SET POINT ENTRY
Function
To enter a Set Point.
Action
1) Hold in the
[F1]
button while turning on the power.
2) Press
[SELECT/F1]
to choose the Set Point you wish programmed. Set Point 1 will be used
for this example.
3) When the display reads "StPt1" press
[ENTER/TARE]
.
4) Determine if the Set Point will be active when the weight is above ("GrEAt") or below
("LESS") the entered value. Press
[SELECT/F1]
to choose the mode. For an overload alarm,
for example, you would choose greater. Press
[ENTER/TARE]
.
5) The current Set Point value will
fl
ash.
6) Press
[SELECT/F1]
to enter the
fi
rst digit of the desired Set Point weight value (Value
cannot exceed scale capacity). Continue to press
[SELECT/F1]
until the desired numeral for
the digit is obtained, then press
[ENTER/TARE]
.
Note:
Pressing
[SELECT/F1]
repeatedly will cycle through numeric values 0 to 9, and then 0 to
9 with the decimal point before repeating the cycle.
7) The next signi
fi
cant digit
fl
ashes. Press
[SELECT/F1]
to enter the next digit. Press
[ENTER/
TARE]
twice after the last character to complete the Set Point entry.
Final
Setup menu is displayed. Press
[CLEAR/ZERO]
to return to normal operation or press
[SELECT/
F1]
to scroll to a different USER Setup operation.
TO DISABLE A SET POINT
Function
To turn off a Set Point.
Action
1) Hold in the
[F1]
button while turning on the power.
2) Press
[SELECT/F1]
to identify the Set Point you wish to disable. Set Point 1 will be used
for this example.
3) When the display reads "StPt1" press
[ENTER/TARE]
.
4) Press
[SELECT/F1]
until the message "OFF" appears. Press
[ENTER/TARE]
. This disables the
Set Point and returns you to the Set Point menu.
Final
Setup menu is displayed. Press
[CLEAR/ZERO]
to return to normal operation or press
[SELECT/
F1]
to scroll to a different USER Setup operation.
TOTAL (totAL)
Function
Allows the TOTAL function to be set or disabled. The USER button must be programmed to
TOTAL in order to view the current TOTAL value, or to use Manual TOTAL.
