MS-7356 Mainboard
2-8
Installing Memory Modules
1. The memory module has only one notch on the center and will only fit in the right
orientation.
2. Insert the memory module vertically into the DIMM slot. Then push it in until the
golden finger on the memory module is deeply inserted in the DIMM slot.
3. The plastic clip at each side of the DIMM slot will automatically close.
Important
You can barely see the golden finger if the memory module is properly inserted
in the DIMM slot.
Volt
Notch
Important
- DDR3 memory modules are not interchangeable with DDR/DDR2 and the
DDR3 standard is not backwards compatible. You should always install DDR3
memory modules in the DDR3 DIMM slots.
- In Dual-Channel mode, make sure that you install memory modules of
the
same type and density
in different channel DIMM slots.
- To enable successful system boot-up, always insert the memory modules
into the
DIMM1 first.
7356v1.0CH2 Hardware Setup.p65
2007/6/13,
下午
02:21
8