MSI 4260B, Operator'S Manual, Page: 37 / 64

15) The display shows “CAL’d”
to indicate that the
calibration was successful.
16) Press TARE. The display
flashes “C-CAL” followed
by the C-CAL number.
Make a note of this number.
If the X1000 annunciator is lit,
also make a note of that.
This number is used to calibrate when
test weights are unavailable. C-CAL
does not replicate multipoint
calibrations.
17) Press ZERO to store the
calibration constants, or
after 8 seconds,the
calibration constants will
automatically stored. After
the Store message is
displayed, the scale goes
to the next item on the Cal
Menu, “SEtuP”.
18) Press ZERO to exit the Cal
menus and start up the
standard weight display.
The 4260 is ready for use.
19) After ensuring the
calibration is acceptable,
replace the Hex Seal Screw.
&&D/
Example Value only.
VWRUH
&$/G
6HWYS
Flashing
ZERO
O
sto
ZERO
O
sto
ZERO
O
sto
TARE
T
ZERO
O
sto
If the scale is being used as a Legal-
For-Trade device, place a Lead-
Wire Seal through the Cal Side
Bored Hex Head Screw over to the
adjacent Side Bored Cap Screw.
To skip the
C-CAL step
14) The display now reads
“LoAd3” or “LoAd4”.
Repeat steps 12 and 13
for additional span points
press
TARE or press
ZERO if you are finished.
After LoAD4 has passed, the 4260
will automatically advance to the next
step.
/RDG
/RDG
or
To enter another
span point
TARE
T
Calibration 33
Figure 5-3. Standard Calibration Procedure (continued)