19
4. Latch the belt over the compressor pulley and press “Tension belt”
(Fig.4, n.7). The belt
tension should be the same as on the car. Check it manually (subjective evaluation). When the
desired tension is reached, press “Tension belt” to stop.
5. Connect lines LP and HP to the appropriate fittings as follows: first high pressure line – HP
(discharge line), then low pressure line – LP (suction line).
Figure 20. Mounting and fixing of a compressor on the Test Bench
Figure 21. Adjusting the belt and checking its tightness
Operation manual - test bench MS111
English
