ULTRA ELITE RESPONDER FACEPIECE
Removing the Inlet Gasket and Disc Valve
1. Remove the spider
gasket.
2. Disassemble the spider gasket.
a. Stretch the disc off
of the stem
Reassembly
Note:
Flow test the facepiece on the PosiChek3 after
reassembly.
Assembling the Component Housing
Install the valve spider (P/N 805011) and disk valve,
speaking diaphragm, drinking tube, and adapter
assembly.
Installing the Inlet Gasket and Disc Valve
1. Gently stretch the valve
disc over the stem.
2. Insert the gasket so that the groove captures the
housing rim.
a. Align the tabbed spoke with the centerline.
Note:
Alignment of the
tabbed spoke with the
centerline provides a visual
guide when installing the
drinking tube assembly
and is not critical to
facepiece function.
Note:
Ensure that the groove captures the component
housing rim. Flex the gasket spider as needed to fully
capture the rim. When installed correctly, the gasket lays
flat and all of the spokes are straight.
3. Reinstall the adapter assembly.
Installing the Adapter Assembly
1. Screw the adapter into the component housing.
a. Ensure that the
corners of the top
flat align with the
notches.
Note:
You can use a piece
1” PVC pipe wrapped with
a few winds of electrical
tape to prevent the inlet
adapter from deforming
while tightening.
9
TAL 012 (L) Rev. 1 - 10096395
