ULTRA ELITE RESPONDER FACEPIECE
5. Moisten the mating surfaces of the facepiece and
housing ring with Snoop (P/N 600920).
6. Check by gently squeezing the ring ends together.
Bulges or wrinkles indicate that the rubber is not
completely captured.
a. Rework the ring until there are no bulges or
wrinkles.
Bulges or wrinkles indicate that the facepiece rubber
is not seated properly. Reinstall the ring so that there
are no bulges or wrinkles. Failure to follow this
warning can cause the facepiece to leak and result in
serious personal injury or death.
7. Use a Phillips
screwdriver to tighten
the component
housing ring screw.
a. Make sure the facepiece rubber does not extrude
between the component housing ring ends.
Note:
On models equipped with ClearCommand
Communication System mounting brackets, install the
mounting bracket and screw provided. (See
Installing the
ClearCommand Communication System Mounting
Bracket
for instructions.)
Installing the Exhalation Valve
Exhalation Valve P/N 814459
1. If necessary, assemble the exhalation valve post to the
valve disc.
a. Lightly lubricate the valve post with Christo-Lube
(P/N 604070).
2. Insert the valve post
into the slot.
If facepiece rubber extrudes between the component
housing ring ends, loosen the ring, adjust, and
reassemble.
Installing the Component Housing Cover
Install the ClearCommand Communication System and
M7 HUD mounting brackets. (See
Installing the
ClearCommand Communication System Mounting
Bracket
and
Installing the M7 HUD Mounting Bracket
for instructions.)
1. Pass the external
drinking tube through
the component housing
cover.
Note:
Verify that the exhalation valve is installed.
2. Carefully insert the tab
into the slot in the
lower lens ring.
3. With one hand inside
the facepiece firmly
press the component
housing and cover
together until they lock.
13
TAL 012 (L) Rev. 1 - 10096395