MSA General Monitors S4000TH, Instruction Manual

Page: 48 / 69

Model S4000TH
40
Address Address
Ch2 Bus Activity
Rate % Bus Activity Rate in % of This
Addressed Node vs. Other
Addressed Nodes Decimal R 0071 40114
Ch2 Function
Code Errors Total # of Function Code
Errors Value 16-Bit R 0072 40115
Ch2 Starting
Addr Errors Total # of Starting Address
Errors Value 16-Bit R 0073 40116
Ch2 No of
Register Errors Total # of Register Errors Value 16-Bit R 0074 40117
Ch2 CRC errors Value 16-Bit R 0075 40118
Ch2 CRC errors Value 16-Bit R 0076 40119
Ch2 Parity
Errors Total parity errors Value 16-Bit R 0077 40120
Ch2 Overrun
errors Total overrun errors Value 16-Bit R 0078 40121
Ch2 Framing
errors Total Framing errors Value 16-Bit R 0079 40122
Ch2 Software
Errors Total Ch 2 Software request
errors Value 16-Bit R 007A 40123
Not used Not used 007B 40124
Ch2 Clear errors Ch2 Clear Hardware errors Bit 0 R/W 007C 40125
Ch2 Clear errors Ch2 Clear Software errors Bit 0 R/W 007D 40126
Not used Not used 007E 40127
Table 11: Command Register Locations
8.8 S4000TH Command Register Details
8.8.1 Analog (00H)
A read returns a value, which is proportional to the 0-20 mA output current. The current is
based on a 16-bit value. The scaling is 0 - 65535 decimal, which corresponds to 0 - 21.7 mA.
8.8.2 Mode (01H)
A read returns the present mode of the S4000TH.
A write command changes the mode to the requested mode. A data value of 08 starts
calibration mode if the unit is in the run mode. It also goes from cal check to cal mode.
Exception: Returns an exception code 01 (illegal function) if an illegal write is requested.
A calibrate command returns an exception code 01 (Acknowledge 05). The operation will take
a long time to complete.