MS ENERGY NEUTRON n3, Instruction Manual

Page: 215 / 244

ENG
18
7 USE AND MAINTENANCE
Tires and other parts
 Electric scooter uses rubber elastic tires. When the tires are worn out or have a
puncture, they need to be replaced timely.
 Contact the official distributor or service to replace the original tires.
 Inspect your scooter and its tires every month, check if the screws are tightened
enough. If they are loose, tighten them.
Battery
 Electric scooter is equipped with a lithium polymer battery. The average lifespan
of the battery is 400 cycles. Under normal use and maintenance, the battery
lifespan can generally reach more than 600 cycles with minimum decreasse of
Battery .
 Before using the scooter for the first time, please charge the battery to the full
charge.

Avoid totally depleting your scooter’s battery before charging. Always make sure
it is minimum 10 % charged. For satisfactory vehicle performance, the battery has
to be charged minimum 50 %
 Do not leave your electric scooter with a significantly discharged battery for a few
hours. Charge it promptly.

When storing the electric scooter for a long period, make sure the battery is at
least 40‐50 % charged. It is advisable to charge your scooter minimum once per 30
days.

Always use only the original charger that corresponds to the model of the scooter.
 Do not leave your electric scooter in the cold temperature below 0 or under the
direct sun. Keep the battery dry. Negative environmental conditions can damage
the battery capacity.
 Polymer lithium batteries have to be treated with extreme caution.
Unappropriated charging, damage or overheating can result in a fire. Do not leave
your electric scooter to charge without supervision. Do not leave the electric
scooter to charge overnight. Always supervise the electric scooter while it is
charging and avoid battery over‐charge. Do not use, charge or leave a damaged
battery unattended and follow the disposal protocols immediately.
Charger
The dedicated charger provided by Factory has a charging protection timing function.
Charging instructions

Open the charging port cover on the electric scooter and insert the charger output
connector into the charging port.
 Insert the charger input power plug into the power socket (AC100V‐240V,
50/60Hz)
 Charger light is red to indicate that charging is in progress; when the charger light
turns green, it indicates that the battery is fully charged.