T: +1-613-545-0466 F: +1-613-542-8029 www.mrel.com
49
4. For each channel of strain that is required to be monitored, the
following equipment is required: a
Pre-Amplifier
,
BNC Extension
Cable
and a
DataTrap II™ Strain Signal
&
Power Cable
.
The
Pre-Amplifier
units may be either 120 ohm or 350 ohm. This
can be seen on the label. Please confirm immediately after receiving
Strain Gauge
equipment that the correct
Pre-Amplifier
units have
been shipped.
5.
DataTrap II™ Data/VOD Recorder
Strain Signal
&
Power Cable
used to connect the
Pre-
Amplifiers
to the
Signal Conditioner
Lid. They are available in two (2) different lengths: 20m
and 100m.
All accessories used for
Strain Gauge
measurement are contained in a case as
shown to the right:
•
8
Pre-Amplifier
units
•
8
BNC Channel Extension Cables
•
1
Signal Conditioner Power Cable
Summary of Contents for DATA TRAP II
