W h e n m o b i l e t h e a u t o c l a v e , p l e a s e p u t t h e a u t o c l a v e a n d
c o n t r o l t h e p o w e r
disconnect, loosen the castor and carefully moving.
Due to
the drainage device at the back of equipment , so please avoid the wall
sockets
and appliances.
When carrying this equipment, avoid put the autoclave sidelong and backward.
When Install and carry equipment, it should be conducted by professional
personnel, handle and put down gently. It is strictly prohibited to severe fall and
collide.
In the process of moving, be careful not to damage or scratch outer cover.
3.Installation and Debug
Installation steps:
1.place of autoclave
：
Put the vertical autoclave on the ground of the smooth, clean and spacious, adjust
the machine feet, make them parallel to the ground, to ensure stable reliable.The
distance between back and sides of the sterilizer and other objects at least 250
mm.
To ensure the ventilation is well.
In addition to keep a safe distance from other objects, the existence of other
objects should not affect the equipment operation.When there is a failure in the
equipment operation, you should be able to cut off the power quickly !
2. Power installation
Please install a dedicated connection for wiring devices at the equipment nearby
buildings. The height is about 1 meter. (such as circuit power supply and load
capacity of the power line should be greater than the rated load of the
equipment.
Advice:
Single-phase AC 220 v ± 10% (50 HZ), more than 25 A.
Please don't put equipment in a place which hard to disconnect the power supply,
make sure that you can disconnect the power supply in case of an emergency.
