8
2
Unpacking and Installation
2.1
Unpacking and Installation
1)
After unpacking the package, please find the operation manual and read it carefully;
inspect all parts according to the packing list.
2)
Move out the frame carefully; put it on the floor steady, and lock the 4 swivel casters.
3)
Before installation, please clean the glass parts carefully to make sure it will meet the
test requirements.
Note: Glassware is fragile; please handle with care when unpacking.
2.2
Installation
For
REAC-NxxLE-3 Series
glass reactors, the glass vessel, lid and frame are pre-assembled
. together. Stirring shaft kit need to be assembled
2.2.1
Installation of Stirring Paddle
Adjust the glass vessel to appropriate height by hand wheel(20), put the stirring paddle(24)
into the vessel, lift up the vessel by rotating the hand wheel(20) until the upper part of the
stirring paddle going through the right port on the reactor lid.
2.2.2
Installation of stirrer shaft
Install the stirrer shaft kit(25) in sequence according to figure 2.2.2.
2.2.3
Installation of motor kit
Connect the fixed frame(32), motor support(16) and motor kit(34) together according to
figure 2.2.3.
Connect the stirring paddle(24) and coupling(33). Tighten the nut(26) to fix the stirring
paddle.
2.2.4
Installation of condenser nozzle
Install the condenser nozzle according to figure 2.2.4.
2.2.5
Installation of condensing dispenser and condenser
As shown in Figure 2.2.5, the tray (38) is mounted on the pole (1), and the condensing
