….
CARE & MAINTENANCE
1.
Unplug the unit and remove the ice basket.
2.
Pull out (upwards towards you) the Silicone Plug which is located at the bottom of the
water tank beneath the ice basket. (See figure 3). Make sure there is a large bucket
or bowl placed underneath the unit to catch the water draining from the ice maker.
3.
Clean the interior with a solution of vinegar and warm water using a soft cloth.
4.
The outside of the ice maker should be cleaned regularly with a mild detergent
solution and warm water.
5.
Dry the interior and exterior with a soft cloth.
6.
Place the Silicone Plug back into the drain area.
7.
When the machine is not in use, be sure to drain water completely from water
reservoir.
8.
To ensure the cleanliness of the ice cubes, water in the water reservoir should be
replaced every 24 hours.
9.
If the compressor stops for any reason such as water shortage, too much Ice, power
outage, etc, DO NOT start the system right away, wait 3 minutes, and then re-start the
ice maker.
10.
Always add fresh water before starting ice production, at initial installation, or after
long shut off periods.
11.
Please clean your Ice maker regularly. Do not spray Ice maker with chemicals or
diluted agents such as acids, gasoline or oil. Rinse thoroughly before starting.
12.
Mold formation can occur if moisture gets trapped inside the unit. Drain unit of water
after every use and ensure the inside of the unit is completely dry before storing.
NOTE:
The Water Filter must be cleaned frequently; at least once a week. Remove
Water Filter from the Draining Hole and clean the filter of any residue by rinsing
with water. If the water filter becomes dirty or clogged, water cannot be
properly drained from the tank. The "ADD WATER" indicator will be illuminated.
Figure 3.
7
