DCA15SPXU4F • OPERATION MANUAL — REV. #1 (02/10/17) — PAGE 19
OUTPUT TERMINAL PANEL FAMILIARIZATION
L5-30R Receptacle
There is one 120V, 30 amp auxiliary L5-30R receptacle
(Figure 5) provided on the control panel. This receptacle
can
only
be accessed when the main and associated circuit
breaker are in the ON position
Voltage Regulator
Turn the
voltage regulator control knob
(Figure 7) on the
control panel to obtain the desired voltage. Turning the knob
clockwise will
increase
the voltage, turning the knob
counter-clockwise will
decrease
the voltage.
Figure 7. Voltage Regulator Control Knob
UVO Output Terminal Access (Hard Wire Hookup
Panel)
The
output terminal lugs
are protected by a insulated
access cover (Figure 8). Remove the bolt that secures the
access cover. Lift the access cover to gain access to the
UVO output terminals.
After the load wires have been securely attached to the
output terminal lugs, pull down down on the access cover
and reinstall locking bolt .
Figure 8. UVO Terminal Lugs
Access Cover
120 VAC GFCI Receptacle
There is one 120 VAC, 20 amp GFCI (Duplex Nema 5-20R)
receptacle provided on the output terminal panel. This
receptacle is protected by a 20 amp circuit breaker. The
breaker can be located on the control panel. Remember
the load output (current) of both GFCI receptacles is
dependent on the load requirements of the U, O, and V
output terminal lugs.
Pressing the
reset
button resets the GFCI receptacle after
being tripped. Pressing the
test button
(See Figure 6) in
the center of the receptacle will check the GFCI function.
Both receptacles should be tested at least once a month.
Figure 6. G.F.C.I. Receptacle
Dual Voltage Twist Lock 120/240 VAC Receptacle
There is one 120/240V, 50 amp auxiliary twist-lock (CS-
6369) receptacle (Figure 5) provided on the control panel.
This receptacle can
only
be accessed when the main and
associated circuit breaker are in the ON position.
L6-30R Receptacle
There is one 240V, 30 amp auxiliary L6-30R receptacle
(Figure 5) provided on the control panel. This receptacle
can
only
be accessed when the main and associated circuit
breaker are in the ON position
NOTICE
Remember the load output (current) on all
four
receptacles is dependent on the load requirements of
the
output terminal lugs.
Summary of Contents for WHISPERWATT Series
Page 38: ...PAGE 38 DCA15SPXU4F OPERATION MANUAL REV 1 02 10 17 GENERATOR WIRING DIAGRAM ...
Page 39: ...DCA15SPXU4F OPERATION MANUAL REV 1 02 10 17 PAGE 39 ENGINE WIRING DIAGRAM ...
Page 40: ...PAGE 40 DCA15SPXU4F OPERATION MANUAL REV 1 02 10 17 BATTERY CHARGER WIRING DIAGRAM ...
Page 41: ...DCA15SPXU4F OPERATION MANUAL REV 1 02 10 17 PAGE 41 ENGINE BLOCK HEATER WIRING DIAGRAM ...
