PAGE 26 — DCA1100SSC 60 HZ GENERATOR • OPERATION MANUAL — REV. #1 (01/17/18)
GENERATOR OUTPUTS
AC Voltmeter Gauge Reading
Place the
AC Voltmeter Chang-Over Switch
(Figure 12
A)
in the WU position and observe the phase to phase voltage
reading between the W and U terminals as indicated on
the
AC Voltmeter Gauge
(Figure 12
B).
Figure 12. AC Voltmeter Change-Over Switch
AC Ammeter Gauge Reading
Place the
AC Ammeter Change-Over Switch
(Figure 13
A)
in the U position and observe the current reading (load
drain) on the U terminal as indicated on the
AC Ammeter
Gauge
(Figure 13
B). This process can be repeated for
terminals V and W.
Figure 13. AC Ammeter Change-Over Switch
U-V
V-W
W-U
OFF
A
B
V
U
W
OFF
A
B
NOTICE
The
ammeter
gauge will only show a reading when
the
bus bar
output terminal lugs
are connected to a
load and is in use.
GENERATOR OUTPUT VOLTAGES
Generator Amperage
Table 7 shows the
maximum amps the generator can
provide.
DO NOT exceed the maximum amps as listed.
HOW TO READ THE AC AMMETER AND AC
VOLTAGE GAUGES
The AC ammeter and AC voltmeter gauges are controlled
by the AC ammeter and AC voltmeter changeover switches.
Both of these switches are located on the control panel and
DO NOT effect the generator output. They are provided to
help observe how much power is being supplied, produced
at the UVW terminals lugs.
Table 6. Voltages Available
Three
Phase
440V
460V
480V
Table 7. Generator Maximum Amps
Rated Voltage
Maximum Amps
3Ø 480 Volt
1323 amps (4 wire)
