MT76D RAMMER • OPERATION AND PARTS MANUAL — REV. #7 (07/14/16) — PAGE 15
OPERATION
INITIAL STARTUP
When starting the MT76D Tamping Rammer perform the
following:
1. The throttle lever is used only at three positions (
stop
,
idle
and
operation
). When moving the lever from the
stop to idle position, press button on lever at same
time lever is moved.
2. Move the throttle lever (Figure 6) to the
idle
position.
Figure 6. Throttle Lever (Idle Position)
CAUTION
Failure to understand the operation of the Tamping
Rammer could result in severe damage to the unit or
personal injury.
NOTICE
In cold weather, the engine should be started at the
operation position or between the idle and operation
position on the throttle lever. Use caution as higher
engine RPM may engage clutch, when engine starts.
Return throttle lever from starting position to idle
position when engine starts
3. Grip the recoil starter handle (Figure 7) and pull it until
you feel a slight resistance.
Figure 7. Recoil Starter
4. Press the decompression lever (Figure 8) to release
decompression. The decompression lever will return
automatically when the recoil starter is pulled.
Figure 8. Decompression Lever
NOTICE
DO NOT
pull the starter rope all the way to the end
and do not let the starter rope snap back as damage
may result.
Summary of Contents for Mikasa MT76D
