!
2.
Into the openings, insert the screw plugs. In two openings marked with
A screw also the screws (leaving 7 mm of screw length outside the
screw plug, Fig.5).
3.
Open the hood cover and remove the fat filter (Fig.6).
4.
Screw the chimney body fastening element, hang the hood on two
untightened screws (Fig. 7).
5.
Place the level on the hood body. Rotating the element marked with
A,
adjust the hood level according the level’s indications, and then tighten
two screws previously screwed partially and screw in two remaining
screws (Fig. 8).
Place the chimney body on the hood body. Then, draw delicately the
hood part signed with
B
upwards, until it becomes possible to screw it
to the fastening element previously attached to the wall (Fig. 9).
NOTE:
this assembly operation shall be performed very
carefully, in order to avoid the scratching of chimney body
and hood itself.
