Troubleshooting
Trouble
Possible cause
Trouble elimination
1*
During the hood operation, the
pulsing "F"symbol is displayed.
After 35 hours of operation, the
hood informs on the need to clean
or replace the fat filter.
Touch and hold for approx.. 8
seconds the "-" touch button.
Wash the filter in the
dishwasher, or replace the filter.
2*
The sign "-." (minus and a point in
the bottom right corner) is
displayed, the hood does not
respond to the attempt to switch it
on.
The touch panel is locked – this is a
function used for the hood cleaning.
To unlock the panel, touch and
hold for approx..10 seconds the
button with a power switch
symbol.
3*
No symbol is displayed, the hood
does not respond to the control
touch buttons.
The touch control panel may be
hanged up.
Turn off the hood power for
approx.. 15 seconds, and switch
it on again.
4*
The speed symbol is displayed, the
hood does not respond to the control
touch buttons.
The touch control panel may be
hanged up.
Turn off the hood power for
approx.. 15 seconds, and switch
it on again.
5*
The hood turbine switches off after
15 minutes of operation, the display
shows, for example, "1." (current
speed number and a point in the
bottom right corner of the display).
The control panel automatic timer
has been activated.
To disable the automatic timer,
press and hold “+” symbol for
approx.. 10 seconds, or switch
the hood off.
6*
At the forth speed, "4" is pulsing,
after 5 minutes the speed is
decreased to a third speed.
The hood is equipped with the turbo
mode, which decreases the speed
automatically for energy saving.
The turbo mode shall be used
for intensive cooking only.
7*
The hood may be controlled with
the control panel only, and it does
not respond to the remote control
commands.
The battery in the remote control is
low, or the distance is too high.
Replace the battery.
8
The hood sucking is too low.
Possible reason: the filters are dirty.
Wash or replace the fat filter.
Replace the coal filter (if any).
9
One or more lights do not light.
Halogen / LED lamp burned-out.
Replace the lamp with a new
one, with characteristics
indicated in the hood Operation
Manual.
10
The hood generates increased noise
and vibrations.
The possible reason may be the
incorrect hood mounting to the wall
or kitchen cabinet. Not all the
required screws have been screwed
in, or they have been left
untightened.
The hood shall be mounted to
the wall or kitchen cupboard in
all point indicated by
manufacturer. After the hood
vertical and horizontal position
adjustment, all the screws shall
be tightened.
* applies to the hoods with a touch control panel
If the above specified recommendations do not solve the problem, contact the authorized house appliances
service centre authorized to perform the repair works. The hood user is not authorized to perform any repairs
himself. The list of service centres may be found in the warranty card, or at our website,.
