MEDIA SETUP Submenus
75
When the Logical Label Length is greater than the Physical Label Length
and Clip Page = Disable, the printer will continue to print the image onto
the next physical label and ignore the gap or mark based on the label
length value set in the MEDIA SETUP menu.
When the Logical Label Length is less than the Physical Label Length, the
printer will print the entire image and leave blank the remaining length of
the physical label as it advances to the Top-of-Form of the next label. This
is true regardless of the Clip Page setting.
The allowable Label Length range is 00.1 to 99.0 inches (2.5 - 2514.6mm).
The factory default is 6 inches. Maximum Label Length range is dependent on
the Label Width value selected, printhead installed (203 or 305 DPI).
NOTE:
See “Set Label Length” on page 85.
Label Width
This option specifies the physical width of the image to be printed. The value
can be specified in inches or millimeters depending on the setting of the Units
submenu under the MEDIA SETUP menu. The allowable range in inches is
0.1 to 4.1 inches. The allowable range in millimeters is 2.5 to 104 mm.
Ver Image Shift
This option specifies the amount to shift an image vertically up (-) toward the
leading edge or down (+) toward the trailing edge for precise positioning on
the label. The actual height of the image is not affected by this parameter.
The allowable range is -1.00 inches to the current Label Length value setting,
up to a maximum of 12.80 inches, in .01 inch increments.
The factory default value is 0.00 inches.
Hor Image Shift
This option specifies the amount to shift an image horizontally outboard (-) or
inboard (+) for precise positioning on the label. The actual width of the image
is not affected by this parameter. The allowable range is -1.00 to +1.00 inches
in .01 inch increments.
The factory default value is 0.00 inches.
Figure 23. This Illustration Shows the Direction of an Image Being Shifted Horizontally
4 inches
6 inches
FEED
Leading Edge
(+) A (-)
