8
Configuration
Figure 2
Com Ports dialogue
Click on the desired Com port number (any can be used that do not conflict with
existing allocations). Press OK to close the dialogue. The new Com port will be
shown in the left hand pane, with the settings in red in the right hand pane.
As a shortcut, the settings can be filled in automatically. Click on the (New) Com
port shown on the left hand pane in Figure 3. Then double-click the found device
shown in the Device List at the bottom of the dialogue. Press the Save button to
save the configuration.
Configuration Test
Network communications can be tested using the Tests tab as in Figure 4.
Press the Open button. If successful, the dialogue will show ``Com Status: Open’’.
Press Close afterwards otherwise the Com port will not be available to LPA-View.
After this configuration, the new ``COM’’ port will be available to the LPA-View
Test Analysis Software. Proceed to connect to the ICM as detailed in the main ICM
manual.
Summary of Contents for ICM-ETHi
Page 9: ...Configuration 9 Figure 3 Com Port Settings Figure 4 Testing ...
Page 14: ......
