13
© 2014 Maka Technologies Group. All Rights Reserved.
Getting Started
Jump Start 12V Car Installation of your MaxPower 6000mAh Power ResQ
Jump Start 12V Car Installation
Warning
•
This power system is to be used ONLY on vehicles with 12 volt DC battery systems.
•
Read your vehicle owner’s manual first as the manufacturer may have specific steps and precautions that
pertain to your vehicle.
•
If available, you should wear safety glasses and gloves while jumping your vehicle.
•
If you are not in a well-ventilated area, please do not attempt to jump start your vehicle.
•
Make sure that your MaxPower 6000mAh PowerResQ has at least 50% charged or has 2 indicator lights
illuminated.
•
Remove any and all USB and/or charging devices connected to the MaxPower 6000mAh PowerResQ.
•
Put your vehicle in PARK and engage the emergency brake.
•
Make sure the vehicle battery terminals, jumper cables and MaxPower 6000mAh PowerResQ are free of any
moisture.
•
Turn off ALL electronics in your vehicle (air conditioner, heater, radio, lights, chargers, etc.) to ensure optimal
performance of your MaxPower 6000mAh PowerResQ.
•
Ensure key is in the “OFF” position in the ignition. For smart-key fobs (push-to-start vehicles), make sure the
vehicle is completely “OFF” before jump starting.
•
Check battery terminals for build-up. If build-up is present try to clean off terminals with a wire brush or a dry
cloth. A clean terminal will provide the
best conductivity between your clamps, vehicle battery, and vehicle.
•
Never touch red and black clamps together — this can cause dangerous sparks, power arcing, and/or explosion.
•
Excessive engine cranking can damage the vehicle‘s starter motor. If the engine fails to start after the
recommended number of attempts, discontinue jump-start procedure and look for other problems that need to
be corrected.
•
The product should NOT be submerged in water, exposed to rain or moisture.
•
Do NOT allow the product or accessories to get wet when in use or storage.
•
Replace worn or defective parts immediately — contact the Customer Service Department at
www.makagps.com
