15
© 2014 Maka Technologies Group. All Rights Reserved.
Getting Started
Jump Start 12V Car Installation of your MaxPower 6000mAh Power ResQ
STEP 6
After a successful start, detach the clamps. First,
disconnect the black clamp and then the red clamp in
that order.
Note:
You should be sure to run your vehicle for at least 15
minutes before shutting the engine off again. If you
have engaged the emergency brake, disengage before
driving your vehicle.
STEP 5
Press start button to turn on Car Jump Terminal.
Smart-Charge Technology
will begin charging your
vehicle’s battery terminal and recharging MaxPower
6000mAh Power ResQ at the same time by diverting
overloaded electricity from the vehicle back to the
device.
Note:
The Car Jump Terminal will automatically switch off if
you have exceeded the time limit of 30 seconds. Press
start button again and proceed to
STEP 6
immediately.
STEP 7
Start the vehicle and leave the engine running. If
the engine fails to start, repeat step 4 to 5 again.
Note:
If the engine fails to start after
3
attempts,
discontinue jump-start procedure and look for
other problems that need to be corrected.
STEP 5
PRESS HERE
STEP 7
STEP 6
