Moxa Technologies INTELLIO C218, User Manual

Page: 13 / 93

Intellio
C218
Turbo
/
PCI User's Manual
2-1
2
2
2
Hardware Installation
The installation of
Intellio
C218
Turbo
/PCI consists of hardware installation and
software installation. For software installation, please refer to the respective section
of operating systems in the next chapter. Hardware installation is stated in this
chapter. The no-switch-no-jumper
Intellio
C218
Turbo
/PCI board’s hardware
configuration for IRQ and memory addresses is automatically assigned by PCI
BIOS . Hence, it is a must to have the board plugged first before installing
software driver . After this, simply install the control board into the PC and then
connect one of the connection cable or box, Opt8A/B/C/D/S/J/F/Z. At the end of this
Chapter, RS-422/RS-485 operation of Opt8J is described.
Installing the
Intellio
C218Turbo/PCI Control Board
Step 1: Power off the PC.
Warning !
Make sure your system is switched off before you start installing any
board. If you don't, you may risk damaging your system and the
board.
Step 2: Remove the PC's cover.
Step 3: Remove the slot cover bracket if present.
Step 4: Plug the
Intellio
C218
Turbo
/PCI firmly into any free 32-bit PCI slot.
Step 5: Fasten the holding screw to make the Control Board fixed.
Step 6: Replace the system cover.