Industio
CP-134U
Series
User’s Manual
3-46
Setserial
Supported Setserial parameters are listed as below.
uart
set UART type (16450-->disable FIFO, 16550A-->enable FIFO)
close_delay
set the amount of time(in 1/100 of a second) that DTR
should be kept low while being closed.
closing_wait set the amount of time (in 1/100 of a second) that the serial port should wait
for data to be drained while being closed, before the receiver is disabled.
spd_hi
Use 57.6kb
when the application requests 38.4kb.
spd_vhi
Use 115.2kb
when the application requests 38.4kb.
spd_normal
Use 38.4kb
when the application requests 38.4kb.
Troubleshooting
The boot time error messages and solutions are stated as clearly as possible. If you exhaust
all possible solutions without solving the problem, please contact our technical support
team for more help.
Error msg:
More than 4 Moxa Smartio/Industio family boards found. Fifth board and after are ignored.
Solution:
To avoid this problem, unplug the 5th, 6th, etc., boards. The Moxa driver supports a
maximum of 4 boards.
Error msg:
Request_irq fail, IRQ address may conflict with another device.
Solution:
Other PCI or ISA devices are using the assigned IRQ. If you are not sure which device is
causing the problem, check /proc/interrupts to find a free IRQ that can be assigned to the
Moxa board.
Error msg:
Board #: C1xx Series(CAP=xxx) interrupt number invalid.
Solution:
Each port within the same multiport board shares the same IRQ. Set one IRQ (IRQ not
