EXPC-1319 Series Hardware
Hardware Installation
2-6
ATTENTION
Safety First!
Be sure to disconnect the power cord before installing and/or wiring your device.
Caution! High Electrical Current!
Verify the maximum possible current for each wire gauge, especially for the power cords. Observe all electrical
codes dictating the maximum current allowable for each wire gauge.
If the current goes above the maximum ratings (120 W), the wiring could overheat, causing serious damage to
your equipment.
Caution! High Temperatures!
Be careful when handling the unit. When the unit is plugged in, the internal components generate a lot of heat
which may leave the outer casing too hot to touch.
Connecting the Power Supply
The power connector is located at the far left of the bottom panel. When wiring the machine for power, refer to
the following figure for the pinout of the M12 power connector. Please take care to guarantee your power cable
uses the correct pinout.
When power has been connected, press the power button on the front panel to turn on the computer.
Connecting the Interfaces
The EXPC-1319 comes with various interfaces located on the bottom panel. All of these connectors have been
shipped with protective caps and tethers. If you wish to detach the tethers from the computer the screws
securing them to the rear panel will need to be removed. To keep water out of the enclosure and preserve the
life of the EXPC-1319, leave the protective caps in place (with their tethers) whenever the hardware interfaces
are not used.
