DA-683 Series
Hardware Installation
Upgrading a DOM
The DA-683 comes with a IDE-based DOM in which the operating system has been installed. To upgrade this
DOM, follow these step.
1.
Disconnect the DA-683 from its power source.
2.
Open the top cover of the DA-683. Refer to the following figure for the specific location for the DOM
installation.
DOM Location
3.
Remove and pull up the DOM carefully.
4.
Insert the new DOM and push downwards to finish.
DOM
Inserting and Removing Expansion Modules
The DA-683 embedded computer has two expansion slots for inserting expansion modules. Expansion modules
can be installed in either on Slot A or Slot B. To insert or remove expansion modules, follow these instructions.
1.
Disconnect the DA-683 from the power source.
2-18
